M-Audio Profire 610 User Manual download pdf (Page 24)

User Guide 23ProFire 610

4. If you are routing signals to Headphone Outputs 1 and 2, make sure the Headphone Level Knobs

are

set properly. Alternatively, if you are routing monitor mixes to external headphone ampliﬁers, make sure

those ampliﬁers are set properly.

When selecting output channels 1/2 from your audio application, the signal is not

sent directly to the physical hardware outputs on the rear-panel of ProFire 610;

The signal is ﬁrst sent to the Analog 1/2 tab of the Control Panel.

By default, the monitor mixer on this Control Panel tab then passes the unaltered

signal on to hardware outputs 1/2. However, this tab gives you additional control

over signals sent to hardware outputs 1/2.

You can use the faders, pan knobs and other controls on the Analog 1/2 tab to

add and blend signals from the physical inputs 1-6 and from the remaining ten

software return channels and create a stereo mix that is then routed to the rear-

panel hardware outputs 1/2.

The same principle applies when selecting output channels 3/4, 5/6, 7/8, or 9/10

from your audio application. These signals are sent to their respective Control

Panel tabs “Analog 3/4”, “Analog 5/6”, “Analog 7/8”, and “S/PDIF Out L/R”, mixed

with other signals if desired, and then routed to their respective analog output

pairs 3/4, 5/6, 7/8, or the digital S/PDIF output.

NOTE: When using the ProFire 610 monitor mixer to create low latency monitor

mixes, be sure to mute your DAW application’s recording channels (or, if

possible, turn off the application’s monitor mixing functionality altogether)

to prevent two separate cue mixes from being created (this can cause

undesirable effects such as phasing and slap-back delays). Conversely,

if you wish to use your application’s own monitor mixing capabilities, you

will need to bypass the ProFire 610 monitor mixers to prevent “double-

monitoring” from taking place. This can be done by simply muting the input

channels of the monitor mixers that you are using.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

No comments

M-Audio Profire 610 User Manual Page 24