M-Audio Omni I/O User Manual download pdf (Page 12)

I/O Setup Primer8

Signal Path Routing for Audio Output

Figure 2 below shows the signal path from the

output of an audio track, through an output bus

mapped to an output path that is routed to a

physical output on an HD I/O audio interface:

1 Audio is played back from disk and routed

from the Track Output to Output Bus “B 1–2.”

2 The Output Bus is defined on the Bus page of

the I/O Setup. On the Bus page of the I/O Setup,

the Output Bus “B 1–2” is mapped to Output

“B 1–2,” which is defined on the Output page of

the I/O Setup.

3 On the Output page of the I/O Setup, the

cross-point matrix routes the output path (to

which the bus output is mapped) to physical

outputs on your audio interfaces.

4 The physical outputs on your audio interface

that are available to Pro Tools outputs are set on

the Main page of the Hardware Setup (this selec-

tor is mirrored in the Output page of the I/O

Setup as shown here).

Figure 2. Output signal path from an audio track to a physical output as mapped in I/O Setup

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

M-Audio Omni I/O User Manual Page 12