M-Audio Omni I/O User Manual download pdf (Page 8)

I/O Setup Primer4

Opening the I/O Setup Dialog

The I/O Setup dialog can be opened and config-

ured whether or not a Pro Tools session is open.

To open the I/O Setup dialog:

1 Make sure your audio interfaces are enabled

and configured properly in the Hardware Setup

dialog.

2 Choose Setup > I/O.

Closing the I/O Setup Dialog

To close the I/O Setup dialog and save changes:

 Click OK.

When you click OK, Pro Tools checks several set-

tings for routing validity (to prevent feedback

loops) and notifies you if there is a problem (see

“Valid Paths and Requirements” on page 21).

To close the I/O Setup dialog without saving

changes:

 Click Cancel.

I/O Settings Pages

The I/O Setup dialog provides tabs to access dif-

ferent pages for configuring I/O Settings.

To open any specific I/O Settings page:

 Click the corresponding tab at the top of the

I/O Setup dialog.

I/O Setup provides the following pages for con-

figuring I/O Settings:

Input Configure input path names, formats, and

source channel (analog or digital). Multichannel

input paths (stereo or greater) can have any

number of sub-paths. You can also have overlap-

ping Input signal paths. Input names, channel

widths, and physical input mappings are stored

with both the system and the session, and can

be recalled from either.

Output Configure output path names and for-

mats. You can have overlapping Output paths.

Output names, channel widths, and physical

output mappings are stored with both the sys-

tem and the session, and can be recalled from ei-

ther.

Bus Configure internal and output bus path

names and formats, and map output buses to

output paths (as defined on the Output page).

Multichannel busses (stereo or greater) can have

any number of sub-paths. Bus names and chan-

nel widths are saved with and recalled from the

session. Output bus paths to output channel

mappings are automatically generated depend-

ing on the defined session output bus paths and

the available system output paths.

I/O Setup dialog for a Pro Tools|HD system with

HD OMNI and HD I/O shown

Press Command+Left or Right Arrow keys

(Mac) or Control+Left or Right Arrow keys

(Windows) to move though the different

pages of the I/O Setup dialog.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Comments to this Manuals

No comments