M-Audio DELTA 1010LT Specifications download pdf (Page 45)

recorded tracks from the software are being sent to WavOut 1, WavOut 2,

WavOut 3, and WavOut 4 simultaneously. Therefore they are all being input

to the monitor mixer and their playback levels can be controlled at the

corresponding channels of the monitor mixer. Open the Monitor Mixer page

of the Delta Control Panel and adjust the levels of the four channels according

to your taste. You may also experiment with the Mute and Solo controls while

listening to the playback. Note also that the mixer continues to monitor the

microphones at analog inputs 1 & 2.

At this point, you should be able to see how this multi-tracking session is developing. As

we add more tracks within our music software, we set them to the next pair of Delta

software outputs (3/4, then 5/6…), and bring up the faders of those software inputs in the

monitor mixer (WavOut 3/4, WavOut 5/6…). We continually monitor from the Delta

hardware outs 1 & 2, via the ‘Mon. Mixer’ setting as the monitor ‘source’ in the

Patchbay/Router page, and adjusting our mix of the software outputs (and the way we

monitor our guitar and vocal at the inputs) via the Monitor Mixer settings.

Notice that if we continue to overdub past track 8, we run out of WavOut devices to assign

to. In this case, you may want to do some of your level mixing within the software

application if it supports it. Most applications will allow you to assign more than one track

to an output device and then set the relative levels of the tracks within the software, letting

the software do the mixing. In this example you could have assigned all of the playback

tracks to "WavOut 1/2" and let the software handle the mix.

Typical Setup #2

Let’s look at a setup that involves a typical transfer of information from DAT to computer

and back to DAT. Here, we’ll be using the Delta 1010LT’s S/PDIF I/O, plus one of the

analog output stereo pairs.

For this setup, we will connect a DAT to the Delta 1010LT PCI Host card using coaxial

S/PDIF cables (75-ohm impedance RCA-to-RCA). We’ll also connect the 1010LT’s

analog outputs to a sound system for monitoring purposes. A setup like this might be used

to transfer a number of mixes from a DAT into an audio editing program, performing the

appropriate edits, and then transferring the edited material back to DAT.

NOTE: Because improper connections can potentially make very

loud noises, it’s a good idea to have monitor levels down while

hooking up audio equipment -- you may even choose to turn your

computer off before making the connections.

The following examples, at first glance, may look rather long and laborious. However, you

will find that most of the settings are factory defaults and will rarely need to be modified.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 58 59

No comments

M-Audio DELTA 1010LT Specifications Page 45