M-Audio RAD-050503 User Manual download pdf (Page 19)

113188-3 www.amdry.com 17

7) The dryer will now display PRESS START. Press the START/ENTER key to start the

dryer. The light emitting diode (L.E.D.) display will read MANUAL DRYING CYCLE,

__MINUTES REMAIN.

NOTE: The dryer can be stopped at any time by pressing the STOP/CLEAR key; at this time the

dryer will go into a cycle pause. If the STOP/CLEAR key is pressed again at this point,

the cycle that was in progress will be cancelled and returned to the READY state.

8) Once the programmed drying time has expired, the Phase 7 non-coin microprocessor controller

(computer) will proceed into the Cool Down Cycle (Mode).

9) Once the Cool Down Cycle begins at the end of the heat cycle, the L.E.D. display will read COOL

DOWN TEMP ___/___ MINUTES REMAINING. At the end of the heat cycle, the dryer will

shut off the heat and continue the fan and basket (tumbler) until the Cool Down Time or temperature

is reached.

10) Once the Cool Down Cycle is completed, the Phase 7 non-coin microprocessor controller (computer)

will proceed into the Wrinkle Guard Cycle. The Audio Alert tone will sound (for the amount set in

Audio Alert On Time). The L.E.D. display will read CYCLE DONE. The dryer will wait an

initial 15 minutes delay before going into a 15-seconds ON, 5 minutes OFF cycle. These times are

fixed and are not programmable. During the ON time, the blower (fan) and the basket (tumbler) will

start to rotate without heat for 15-seconds, during this time the display will read WRINKLE

GUARD. After the 15-seconds are completed, the display will read CYCLE DONE and the

dryer will go into a 5 minute OFF cycle. The Phase 7 non-coin microprocessor controller (computer)

will repeat this process of 15-seconds ON and 5 minutes OFF until either the doors are opened,

the STOP/CLEAR key is pressed, or 99 minutes have elapsed, whichever comes first. Once

the 99 minutes have elapsed, the L.E.D. display will then read CYCLE DONE and will lock out

the dryer functions until the doors are opened. The L.E.D. display will then return to READY.

B. OPERATING NOTES

1. Steam injection will only operate when the dryer is running.

2. The RPM of the basket (tumbler) can be displayed by pressing and holding the DOWN ARROW key

while a cycle is in progress. If a cycle has not been started, the display will read CPU Board Voltage

Value. (23-26 Volts is normal).

3. The dryer can be stopped at any time by pressing the STOP/CLEAR key; at this time the dryer will go

into a cycle pause. If the STOP/CLEAR key is pressed again at this point, the cycle that was in

progress will be cancelled and returned to the READY state.

4. When programming a Manually Loaded Cycle, if an error is made when making an entry, press the STOP/

CLEAR key ONCE, and the entry will be cancelled. Reenter the selection. If the selection is entered

and an error is made, the STOP/CLEAR key will cancel the program and return to READY state.

5. Use the UP ARROW and the DOWN ARROW to scroll through menus or to increase/decrease

the number values, or to toggle between choices.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 89 90

No comments

M-Audio RAD-050503 User Manual Page 19