M-audio Flying Calf User Manual

Table of ContentsFCC Class B and CE Compliance ... 2Overview ...

Jumpers JP2 and JP3 control theinput levels to the LEFT andRIGHT audio channels, respec-tively. When set to the"Standard" position, theyacc

11However, if SCMS is enabled: When ORIGINAL isinstalled, data is flagged as a COPY. When ORIGI-NAL is not installed, data is flagged as ORIGINAL.Tro

12SpecificationsPhysical Specifications:Size: Approximately 6.3” x 3.6” x 1.2”.Power Supply: 9 volt DC, center-pin positive, 500 ma. or larger.Audio:A

2FCC Class B and CE Compliance WARNING: This equipment has been tested and found to comply with the lim-its for a CLASS B digital device, pursuant to

3harsh computer environment. This improves the signal-to-noiseand dynamic range performance dramatically over a typical (oreven professional) sound ca

4Features• High-quality, 24-bit stereo, A/D converter.• Unbalanced analog inputs on independent left and right1/4” jacks. • S/PDIF digital output on a

57. S/PDIF Out: This female RCA jack outputs a standardS/PDIF digital audio signal. The S/PDIF signal is "stereo,"containing both left chan

6FLYINGCalf A/DS/PDIFInDIGITAL AUDIOCARD(Inside PC)S/PDIFOutAnalog InRightAnalog InLeftIn 4In 3In 2In 1MixerLine OutLeftRightTypical Setup - Fig. 2

7After all connections are made, power up the Flying Calf bypressing the power button on its front panel.IMPORTANT: Before powering up the Flying Cal

8The level of the analog signal that goes into the Flying Calf shouldbe adjusted for optimum A/D sampling quality. For best conver-sion, the input si

9Internal Jumper SettingsThere are four configuration jumpers inside the Flying Calf chas-sis. Typically you will never need to open the Flying Calf