M-audio OmniStudio USB User Manual download pdf (Page 39)

Problem: No sound.

Possible Cause 1: Drivers have not been correctly installed, or the OmniStudio USB has not been properly configured in your audio software.

Possible Cause 2: Audio connections have not been properly made. Check your connections and your cables for continuity.

Problem: On my Mac, I cannot select the OmniStudio USB ASIO driver in my audio software.

Possible Cause: If the OmniStudio USB’s ASIO driver has not been copied to the correct folder (e.g., the ASIO folder in the System Folder,

rather than the ASIO folder in your audio software’s ASIO folder), it will not be recognized by your application.

Problem: I hear clicks and pops in my audio.

Possible Cause 1: This could be due to another device’s drivers polling the CPU and interfering with the USB bus. Refer to Section 13,

“Optimizing Your System for Audio” for more information.

Possible Cause 2: You may need to raise the latency setting in the OmniStudio USB control panel. On slower systems, it’s sometimes

necessary to run larger buffers (higher latency setting) to increase system stability.

14. Troubleshooting

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45

No comments

M-audio OmniStudio USB User Manual Page 39